Center Pivot Irrigation Saves Water, Too

If you've ever flown across the United States, then you've most likely observed center pivot irrigation. Center pivot irrigation is the cause for the green or brown circles or half-circles that you noticed on the earth below. This type of crop watering system has been very effective at creating valuable farmland out of previously unusable dry or even desert ground.

To illustrate, you might picture a wire spoke from a bicycle wheel. The water source is at the hub, or center, of the spoke, and the spoke itself moves around the hub. Sprinkler heads then spray or sprinkle the growing crops from the trusses, or from hoses that dangle below the trusses just a few inches above the plants. Two important benefits of pivot irrigation are that crops receive regular, consistent water, and that water evaporation and wind drift are greatly reduced. Gardeners know that plants need regular, deep watering to produce healthy fruits. Watering deeply encourages the plant roots to sink deeply into the ground. This in turn produces plants that are strong and sound. Deep roots allow plants to take advantage of vitamins and minerals located deep within the soil.

A second benefit to center pivot irrigation is that water loss is minimized. Particularly in dry areas, water evaporation and wind drift can result in a major loss of water to crops. For example, in the high plains where strong winds are common, wind drift can prevent water from reaching the plants on the ground. Also, warm dry air will cause water to evaporate at a much higher rate than other places. Center pivot irrigation allows water to be spot-directed. The hoses that dangle just a few inches above the plants makes sure that the vast majority of available moisture reaches the plants and is not lost to evaporation. This results in water conservation.
Center Pivot Irrigation - What Is It? Irrigation is simply providing water to crops on a regular basis. Center pivot irrigation begins with a water source, usually in the center of a field. This source can be a well, canal, or other consistent water supply. From the water source, pipes or hoses allow the water to be transported through trusses along the entire length of a field. The trusses hold the pipes up off the ground and over the plants growing beneath. The trusses are connected with wheeled supports, which allow the pivot to move slowly around the field.

The same is true for crops raised on a large scale. Pivot irrigation allows the farmer to determine how much water the plants receive, as well as how often the plants receive that water. A typical pivot will make a complete rotation every 3 days, giving the water time to soak into the soil. The soil is allowed to dry out between watering so that crops do not stand in water, which can kill them.

There are five major providers of center pivot irrigation supplies and technology. These are T-L Irrigation, Valley (also known as Valmont Irrigation), Raintex Irrigation, Reinke and the Lindsay Corporation. T-L Irrigation is the only company manufacturing hydrostatic equipment, which is where the pivot is powered by water propelling the pivot around the field. The other manufacturers create equipment that is powered by 480 volt electricity. Some drawbacks to electric equipment include complaints that the pivot "jerks and starts." The propelling motors and other equipment start and move forward when told to do so by sensors, not in a continuous motion. This can result in more wear-and-tear on the equipment, meaning that there may be additional maintenance costs.

For More Information: - http://valleysprinkler.com/

John Mike
Valley Sprinkler we work hard to build our reputation on service, support, and excellence lawn watering system installations at a low competitive yet highly affordable price.